快乐赛车

[1]朱志豪,袁端磊,费 翔,等.带双侧隔离开关的新型12 kV开关柜研制[J].高压电器,2020,56(02):221-225.[doi:10.13296/j.1001-1609.hva.2020.02.033 ]
 ZHU Zhihao,YUAN Duanlei,FEI Xiang,et al.Research and Manufacture of a Novel 12 kV Switchgear with Two-side Disconnectors[J].High Voltage Apparatus,2020,56(02):221-225.[doi:10.13296/j.1001-1609.hva.2020.02.033 ]
点击复制

带双侧隔离开关的新型12 kV开关柜研制()
分享到:

《高压电器》[ISSN:1001-1609/CN:61-11271/TM]

卷:
第56卷
期数:
2020年02期
页码:
221-225
栏目:
技术讨论
出版日期:
2020-02-14

文章信息/Info

Title:
Research and Manufacture of a Novel 12 kV Switchgear with Two-side Disconnectors
作者:
朱志豪 袁端磊 费 翔 马明乐 冯祥伟 王海燕 祁海洋
(平高集团有限公司, 河南 平顶山 467001)
Author(s):
ZHU Zhihao YUAN Duanlei FEI Xiang MA Mingle FENG Xiangwei WANG Haiyan QI Haiyang
(Pinggao Group Co., Ltd., Henan Pingdingshan 467001, China)
关键词:
移开式开关柜 固定柜 小型化 隔离开关 电场优化
Keywords:
withdrawable switchgear fixed switchgear miniaturization disconnector electric field optimization
DOI:
摘要:
为了解决手车移开式开关柜电场不均、隔离手车可靠性不易提升等问题,提出了一种新型空气绝缘金属封闭开关设备的设计方案,该方案集中了移开柜和固定柜的优点,它的主要特点是从柜前看三相主回路后中前纵向布置,主回路主要采用圆形导体,真空灭弧室两侧设有直动式隔离开关。对该方案的设计实现思路进行了分析,采用有限元方法对电场进行了仿真,结果显示该方案电场分布明显优于通常采用矩形铜排的开关柜。制造了采用该方案的12 kV/ 1 250 A产品样机,并通过了全套试验,该样机达到了柜宽仅500 m、主导电回路缩短从而节约大量有色金属、整机局部放电量<10 pC的效果,实现了中压空气绝缘开关柜兼具小型化、双隔离和优异绝缘性能的特点,促进了中压开关柜的多元化发展。
Abstract:
In order to solve the problem of uneven electric field and poor reliability of the withdrawable switchgear. The paper presents a novel design scheme of the air insulation metal-enclosed switchgear, which combines the advantages of removable and fixed switchgears. Its main features are as follows: the three-phase main circuits are longitudinal layout from back to front if looking from the front of the cabinet, and the main circuit is mainly composed of circular conductors, with a linear moving disconnecting switch on each side of the vacuum interrupter. The reasons for this design and the ways to achieve it are discussed. The model’s electrical field is calculations by finite element method, the results show that its electric field is obviously superior to the switchgears which usually adopt rectangular conductors. A typical 12 kV/1 250 A product prototype of this design is manufactured and tested. Its width is only 500 mm. The partial discharge of the whole switchgearis less than 10 pC, and the main conductive circuit is greatly shortened, so a lot of material is saved accordingly. It is achieved that the switchgear combines the characteristics of miniaturization, with two-side disconnectors and excellent insulation performance, which promotes the diversified development of medium voltage switchgear.

参考文献/References:

[1] 黎 斌,王日新,王 君,等. 对中压配电柜各种主绝缘的思考——兼评抽出式紧凑型空气绝缘环网柜的特点[J]. 高压电器,2016,52(8):7-13. LI Bin,WANG Rixin,WANG Jun,et al. Thoughts on various kinds of main insulation of medium voltage distribution cabinet-comment on the characteristics of withdrawable compact air-insulated RMU[J]. High Voltage Apparatus,2016,52(8):7-13.
[2] 兰 剑,王承玉,李庆余. 中国配电开关应关注的发展热点[J]. 高压电器,2015,51(10):217-220. LAN Jian,WANG Chengyu,LI Qingyu.The development hot spots that China’s power distribution switches should pay attention to[J]. High Voltage Apparatus,2015,51(10):217-220.
[3] 崔成恕,高 华. 金属封闭开关设备的发展简析[J]. 高压电器,2003,39(2):18-22. CUI Chengshu,GAO Hua.Development of metal enclosed switchgear[J]. High Voltage Apparatus,2003,39(2):18-22.
[4] 钱家骊,袁大陆,杨丽华,等. 高压开关柜—结构、计算、运行、发展[M]. 北京:中国电力出版社,2006:4-20. QIAN Jiali,YUAN Dalu,YANG Lihua,et al. Structure,calculation,functioning,development of high voltage metal-enclosed switchgear[M]. Beijing:China Electric Power Press,2006:4-20.
[5] MARTIJN I,ENGBERSEN H.Fixed or withdrawable switchgear — withdrawable switchgear, past or future[C]//in Proc. 2011 Petroleum and Chemical Industry Conference Europe Conference Proceedings-IEEE. [S.l.]:IEEE,2011:1-6.
[6] MARTIJN I, VERMEER M,ONKELEN R V. Benefits of withdrawable switchgear and motor control centres[C]//-in Proc. 2012 Petroleum and Chemical Industry Conference Europe Conference Proceedings-IEEE. [S.l.]:IEEE,2012:1-10.
[7] 高继法,韩宏先. 40.5 kV移开式开关柜改为固定柜在供电系统中的应用[J]. 高压电器,2003,39(4):70-71. GAO Jifa,HAN Hongxian.Application of 40.5 kV move-out switchgear to fixed cabinet in power supply system[J]. High Voltage Apparatus,2003,39(4):70-71.
[8] 黄新波,王海东,胡海燕,等.高压开关柜电动底盘车防堵转技术与应用[J]. 高压电器,2018,54(3):205-211. HUANG Xinbo,WANG Haidong,HU Haiyan,et al.Technology and application of avoiding locked rotor fault of HV switchgear electric chassis[J]. High Voltage Apparatus,2018,54(3):205-211.
[9] 李端姣. 10 kV系统用移开式开关柜潜在缺陷的改进研究[J]. 高压电器,2013,49(2):110-115. LI Duanjiao.Improvement of potential defects for 10 kV system removal-type switchgear[J]. High Voltage Apparatus,2013,49(2):110-115.
[10] 丁 健. 金属封闭高压开关柜触头发热机理分析及预防过热故障措施探讨[J]. 高压电器,2012,48(8):114-117. DING Jian. Heating mechanism analysis on metal-enclosed high voltage switchgear contact with measures to prevent overheating[J]. High Voltage Apparatus,2012,48(8):114-117.
[11] 马保军,吴传红.高压开关柜内接头发热事故的分析及解决[J]. 河南科技,2010(10):77-78. MA Baojun,WU Chuanhong. Analysis and solution of contact fever accidents in high voltage switchgear[J]. Henan Technology,2010(10):77-78.
[12] 王红艳. 12 kV可移开式手车断路器的电动力分析及设计改进[J]. 高压电器,2016,52(9):50-54. WANG Hongyan.Electrodynamic analysis and design improvement of 12 kV removable handcart circuit breaker[J]. High Voltage Apparatus,2016,52(9):50-54.
[13] 周立福. 10 kV 变低开关柜发热造成主变跳闸的故障分 析及改进措施[J]. 电源技术应用,2012(12):62. ZHOU Lifu.Failure analysis of main transformer trip caused by heating of 10 kV switch cabinet and improvement measures [J]. Application of Power Technology,2012(12):62.
[14] 王秉政,江健武,赵 灵,等. 高压开关柜接触发热温度场数值计算[J]. 高压电器,2013,49(12):42-48. WANG Bingzheng,JIANG Jianwu,ZHAO Ling,et al.Numerical calculation of contact heating temperature field in high voltage switchgear[J]. High Voltage Apparatus,2013,49(12):42-48.
[15] 严 璋,朱德恒. 高电压绝缘技术[M]. 北京:中国电力出版社,2002. YAN Zhang, ZHU Deheng. High voltage insulation technology[M]. Beijing: China Electric Power Press,2002.
[16] 钱立骁,陈慎言. 12~24 kV氮气绝缘环网柜的研制[J]. 高电压技术,2014,40(12):3717-3724. QIAN Lixiao,CHEN Shenyan.Research and design of 12~24 kV nitrogen insulated ring main unit[J]. High Voltage Engineering,2014,40(12):3717-3724.
[17] 徐国政,张节容,钱家骊,等. 高压断路器原理和应用[M]. 北京:清华大学出版社,2000. XU Guozheng,ZHANG Jierong,QIAN Jiali,et al. Theories and applications of high-voltage circuit breaker[M]. Beijing:Tsinghua University Press,2000.
[18] 潘长明,刘 刚,熊 炬,等. 高压开关柜绝缘事故的分析及防范措施[J]. 高压电器,2011,47(7):90-93. PAN Changming,LIU Gang,XIONG Ju,et al.High voltage switchgear insulation accident’s analysis and countermeasures[J]. High Voltage Apparatus,2011,47(7):90-93.
[19] 张会建. 一起因开关柜故障而导致的变压器事故分析[J]. 变压器,2017,54(9):80-81. ZHANG Huijian.A transformer accident analysis caused by a switchgear fault[J]. Transformer,2017,54(9):80-81.
[20] 3.6 kV~40.5 kV交流金属封闭开关设备和控制设备:GB 3906—2006[S]. 2006. Alternating-current metal-enclosed switchger and controlgear for rated voltages above 3.6 kV and up to and including 40.5 kV :GB 3906—2006[S]. 2006.
[21] 高压开关设备和控制设备标准的共用技术条件:GB/T 11022—2011[S].2011. Common specifications for high-voltage switchgear and controlge:GB/T 11022—2011[S].2011.

备注/Memo

备注/Memo:
收稿日期:2019-10-18; 修回日期:2019-12-18基金项目:国家电网公司总部科技项目(一二次融合的配电设备可靠性技术研究及设备研制)资助。Project Supported by Science and Technology Project of State Grid Corporation of China(Reliability Technology Research and Development of Distribution Equipment Based on Primary and Secondary Integration).朱志豪(1985—),男,硕士,工程师,主要从事中压开关柜和断路器等产品的研发工作。
更新日期/Last Update: 2020-02-14